How to change an AR-15 pistol grip

One screw holds the grip on. One small spring is waiting to escape when you take it off.

Last reviewed November 22, 2026. How we evaluate

What you need

  • The new grip and its screw and washer
  • A long hex key or flat screwdriver, to suit the screw
  • A clean surface where small parts cannot roll away

Know the part you can lose

The pistol grip holds the safety selector’s spring and detent in place. The detent is a small pin in the receiver. The spring sits in a hole in the top of the grip. Take the grip off carelessly and one or both will fall out.

Steps

  1. Unload the rifle and check the chamber. Remove the magazine.
  2. Turn the rifle upside down so the grip points up. Gravity now keeps the detent in the receiver.
  3. Reach into the bottom of the grip with your tool and unscrew the grip screw.
  4. Lift the grip straight off slowly. The selector spring will be standing in the grip or in the receiver. Set it aside.
  5. Confirm the detent is still in its hole in the receiver, pointed end toward the selector.
  6. Place the spring in the small hole in the top of the new grip.
  7. Lower the new grip onto the receiver, guiding the spring into the detent hole without bending it.
  8. Start the screw by hand, with its washer, then tighten until snug. The threads are in aluminum, so do not force it.
  9. Turn the rifle upright and work the safety selector. It should click firmly between positions. If it spins freely, the spring or detent is missing or misplaced.

Questions people ask

Do I need thread locker on the grip screw?

A small drop of medium-strength thread locker is common practice. A lock washer does the same job.

My selector feels mushy after the swap.

The spring is probably kinked or not seated in the grip. Take the grip off and check it.