How to install a slip-on grip sleeve
A tight sleeve is a good sleeve. The trick is getting it on without a fight.
Steps
- Unload the pistol, remove the magazine and check the chamber.
- Clean and dry the grip.
- Read the maker’s sheet. Common methods are warming the sleeve in hot water to soften it, or wetting the inside with a little rubbing alcohol, which evaporates. Do not use oil or grease.
- Start the sleeve over the bottom of the grip with the finger grooves facing forward.
- Work it upward a little at a time, alternating front and back, until the cutouts line up with the controls.
- Check that the magazine release, slide stop and takedown lever move freely.
- Insert an empty magazine. It should lock in and drop free. If the sleeve hangs below the frame and blocks the magazine, push it up or trim it if the maker allows.
- Let any alcohol evaporate before use.
If the pistol has a grip safety
Do not fit a sleeve unless the maker lists your exact model. A sleeve can cover the safety or hold it down. See grips for the S&W Equalizer and Shield EZ.
Questions people ask
How do I remove a grip sleeve?
Roll it down from the top like a sock. A little rubbing alcohol under the edge helps.