How to install and remove bike grips

Lock-ons need a hex key. Push-on grips need rubbing alcohol or compressed air, and never oil.

Last reviewed November 22, 2026. How we evaluate

Lock-on grips

  1. Loosen the clamp bolts and slide the old grips off.
  2. Clean the bar.
  3. Slide the new grip on with the clamp in the position the maker shows, and rotate any shaped grip to the right angle.
  4. Tighten the clamp bolts to the torque printed on the collar. Carbon bars are easy to crush, so use a torque wrench.
  5. Fit bar end plugs if they are separate.

Push-on grips

  1. To remove old grips, lift the edge with a thin screwdriver and squirt in rubbing alcohol, then twist. Compressed air under the edge works even better.
  2. Clean the bar and let it dry.
  3. Wet the inside of the new grip and the bar with rubbing alcohol.
  4. Push the grip on quickly, in one motion, and adjust its position before the alcohol flashes off.
  5. Leave it for a few hours before riding hard.

What not to use

Oil, grease and soapy water can leave a film that lets a grip rotate later. Alcohol evaporates completely. Hairspray is an old trick that works as both lubricant and glue.

Questions people ask

My push-on grips keep twisting.

The bar or grip was contaminated, or water is getting in. Remove, clean with alcohol and refit, or switch to lock-ons.