How to install motorcycle grips
Glue, a gap at the throttle housing, and a check that the throttle snaps shut. That last one is not optional.
Steps
- Remove bar-end weights if fitted. Cut the old grips off carefully, or lift the edge and use compressed air.
- Clean old glue off the bar and the throttle tube. Inspect the throttle tube for cracks.
- Identify the grips. The one with the larger bore goes on the throttle tube.
- Apply grip glue to the bar or tube as its instructions describe.
- Push the clutch-side grip fully onto the bar and align the pattern.
- Push the throttle grip onto the tube, leaving a small gap between the grip flange and the switch housing so nothing drags.
- For off-road use, add safety wire in the grooves provided and twist the ends so they tuck into the grip.
- Refit bar ends. Let the glue cure for the time stated.
- Check the throttle snaps shut at every steering position before you start the engine.
Lock-on grips
Lock-on motocross grips replace the throttle tube. Fit the cam that matches your bike, slide the assembly on and tighten the clamps. No glue or wire is needed.
Questions people ask
Can I use hairspray instead of grip glue?
It works on a bicycle. On a motorcycle throttle, use proper grip glue.