How to install grip tape on a pistol

Clean the frame properly, line up one reference edge, and use heat. Ten minutes of care adds a year to the wrap.

Last reviewed November 22, 2026. How we evaluate

What you need

  • The wrap cut for your exact model and generation
  • Isopropyl alcohol or the prep pad supplied
  • A hair dryer
  • Clean hands

Steps

  1. Unload the pistol and remove the magazine. Check the chamber.
  2. Fit the backstrap or palmswell you intend to keep, if your pistol has them.
  3. Wipe the whole grip with alcohol to remove oil and let it dry fully. Adhesive fails on oily polymer.
  4. Hold the wrap against the frame with the backing still on. Find the feature it lines up with, usually the magazine release cutout or the edge under the trigger guard.
  5. Peel the backing. Lay down the reference area first, lightly, and check alignment before pressing.
  6. Work around the grip a section at a time, smoothing from the middle outward so no air is trapped.
  7. Warm the wrap with a hair dryer until it is warm to the touch, then press it firmly into the frame texture with your palm. Repeat once.
  8. Press down every edge and seam. Insert a magazine and confirm it locks and drops free.
  9. Leave it for a day before holstering if you can, so the adhesive reaches full strength.

Removing it later

Warm the wrap with the hair dryer and peel slowly from a corner. Rub off any residue with isopropyl alcohol. See cleaning and restoring grips.

Questions people ask

Can I reposition a wrap?

Usually once or twice before you press and heat it. After heating, lifting it weakens the adhesive.

My edges are lifting. What went wrong?

Almost always oil on the frame or too little heat. Clean under the edge, reheat and press. If it keeps lifting, replace the wrap.