How to replace 1911 grips

Four screws, two panels. The details are the bushings and not overtightening.

Last reviewed November 22, 2026. How we evaluate

Steps

  1. Unload the pistol, remove the magazine and check the chamber.
  2. Use a screwdriver or bit that fits the screw slots exactly. A loose fit chews up the screws.
  3. Remove the four grip screws and lift the panels straight off.
  4. Check the bushings, the threaded sleeves the screws go into. If one came out with its screw, separate them and thread the bushing back into the frame firmly.
  5. If you are fitting thin panels, replace the bushings and screws with slim versions.
  6. Set the new panels over the bushings. They should sit flat without rocking. With an ambidextrous safety, make sure the right panel sits over the safety’s retaining tab.
  7. Install the screws until snug. Overtightening cracks wood and strips bushings.
  8. Check that a magazine drops free, the thumb safety and slide stop work, and nothing binds.

Other pistols with panels

The same approach applies to the Beretta 92 and CZ 75. Thin aftermarket panels may need the shorter screws their makers supply.

Questions people ask

Should I use O-rings under 1911 grip screws?

Small rubber O-rings help screws stay put without overtightening. Many shooters use them.